ELERIX Lithium Cell LiFePO4, Prismatic 3,2V 100Ah, 1C

Industrial lithium cell with high energy density and capacity of 100 Ah, manufactured based on safe LiFePO4 technology. The battery is made from quality materials and contains no toxic chemicals, which guarantees long service life.

LiFePO4 is a very safe technology, without spontaneous ignition, fire and explosion. The self-discharge rate is very low. There is no memory effect - cells can be recharged at any state of discharge.
All ELERIX cells are thoroughly tested in Tier 1 factories before distribution, both during production and before shipping. The ELERIX brand is characterized by high quality of its cells, which are primarily Grade A.

• Aluminum housing (case)
• High performance up to 1C, 100 A discharge
• Provides high current at peak discharge (2C, 200 A)
• 3000 cycles / 15 years lifespan
• No toxic chemicals
• Suitable for electric vehicles, energy storage, solar and light applications

How to connect cells
See the use of long and short connectors for EX-L100.

Discharge test
The following graph shows the discharge capacity test.

Operating instructions

• Always charge cells to full voltage before first use.
• Initial charging must be performed with low current at max. 0.5C - i.e. 50 A for a 100 Ah cell.
• Protect cell terminals from contamination, damage and short circuit.
• Cells must be monitored and protected against deep discharge and overcharge.
• Charging and discharging must be carried out under supervision.

Initial charging
Cells are pre-charged by the manufacturer to storage charge (usually 30–50%). Before first use, cells must be charged with low current. The first charge should not exceed 0.5 C - e.g. for a 100 Ah cell this is 50 A.
When initially charging multiple cells, connect them in parallel and the charger outputs should be connected to both ends of the parallel cell rows.

We recommend using chargers specially made for LiFePO4 cells. The first charge and initial balancing of the entire set is an important step to achieve long service life.
Alternatively, you can use a regulated (laboratory) power supply as a tool for initial charging.

BASIC SPECIFICATIONS

Type: LiFePO4
Capacity: 100 Ah
Nominal voltage: 3.2 V
Operating voltage: 2.5–3.65 V
Maximum charging voltage for initial charging: 3.65 V
Energy density: 156 Wh/kg
Recommended tightening torque: up to 10 Nm
Maximum discharge current: 1 C
Peak discharge current: 200 A (max. 30 sec)
Operating temperature (discharge): 0 °C to 50 °C
Operating temperature (charging): 0 °C to 50 °C
Storage temperature: -10 °C to 35 °C
Dimensions: 215.8 × 130.4 × 37.5 mm
Weight: 2.05 kg